An SCR topology transmogrifies into BJT two-wire precision current source with a self-resetting fault-current limiter.

Current source inverters and converters represent a crucial class of power electronics devices that convert direct current from a constant current source into alternating currents with precise control ...

It has long been known that the simple combination of a depletion-mode MOSFET (and before these were available, a JFET) and a resistor made a simple, serviceable current source such as that seen on ...

Before the LT3092, the simplest current source was merely a voltage source with a resistor in series feeding the load resistance. Assuming the load resistance is much smaller than the series resistor, ...

Author Mazi Hosseini describes a simple, low-cost, voltage-controlled current source using two op amps that provides a good range of current and maximum load. One challenge in circuit design is ...

The LM334 is not only an adjustable current source, but it is also a rectifier. Right on the front page of the TI data sheet are the words: “Reverse applied voltages of up to 20V will draw only a few ...

At first glance, [RobBest]’s constant current source looks old school. The box is somewhat old-fashioned, featuring switches and binding posts. Most importantly, there’s a large analog meter ...

At first glance, [RobBest]’s constant current source looks old school. The box is somewhat old-fashioned, featuring switches and binding posts. Most importantly, there’s a large analog meter ...

This article describes the composite current source (CCS) noise modelfor cell-level noise analysis. CCSisa modeling capability in the open-source Liberty cell modeling standardthat encompasses timing, ...